How to Lay Paving
Ground Preparation
Remove all topsoil and dig down enough to reach hard ground for a good foundation.Work out finished level of paving, work out falls in finished surface to remove surface water and calculate level of top of stone base by deducting depth of paver and 30mm for bed of sand.
For patios, a minimum of 100mm of stone is preferred, while under a driveway, use a minimum of 150mm.(ask supplier for recommendations on stone type to use.)
Lay stone to required depth and compact with plate vibrator. Make up and compact where necessary to leave only 50mm of base sand depth.
Lay kerb or header paver as edge restraint.
You are now ready to begin paving area.
Sand Laying Course
Set up levels to create falls to gullies or channels.Choose a course concrete sand.
Spread an even layer deep enough to allow for compaction.
Sand Compaction
Compact sand using a plate vibrator
Make sure to overlap all passes with vibrating plate
Set up Screeds
Set up screed boards in sand
Top of board set to 5mm above finished level for bottom of paver
Set boards to create falls to drainage gullies or channels etc
Screeding
Screed sand on top of screed boards with a straight piece of timber or aluminium
Always screed off compacted sand, add more sand and compact if sand not high enough
Fill remaining Area
When sand screeded remove the screed boards fill and compact the void left.
Screed off remaining areas
Carefully screed off these areas to level of surrounding sand.
Laying Paving
Choose pattern to lay paving to.
Set up a builders line as a guide to begin laying paving blocks.
Lay all blocks
Continue laying until all full blocks have been laid.
Lay header / string course
Lay header or string courses along edges to create feature.
This also leaves cutting much easier.
Cut Blocks
Choose method of cutting blocks along edges
Use either power saw or guillotine
Carry out all cutting before moving to next process
Compact Paving
After checking and adjusting straightness of lines begin compacting paving with plate vibrator.
Compact entire area.
Do not compact closer than 1 metre from any unrestrained edge.
Fill joints
Spread jointing sand and brush into joints.
Fill joints level to top of pavers.
Compact Sand
Compact sand into joints using plate vibrator.
Top up Joints
Top up joints with jointing sand.
Remove excess sand from surface leaving only a small amount on the surface.
